Pump Technology Catalogue 2019

6 IF YOU HAVE ANY INSTALLATION QUERIES PLEASE TELEPHONE OUR TECHNICAL DEPT. BEFORE INSTALLATION. Due to a policy of continuous product improvement we reserve the right to alter specifications without notice Electrical Data Pump Current Type Voltage Motor Power R.P.M. F.L.C. Motor Plug Volts P1 P2 Min -1 Amp Protection PTL 30 1 Phase 230 0.32 0.20 2720 1.4 Incorporated Safety DRAINMINOR DOMESTIC, LIGHT COMMERCIAL , WASTE WATER PUMPING SYSTEM Low Level Float Must be fitted for Shower, Washing Machine, Dishwasher DRAINMINOR: This consists of a durable tank manufactured from poly ethylene laminate. QUALITY: The tank is pigmented throughout with an externally smooth isophthalic polyester gel coat and resin enriched lining. OUTLETS: The tank has a 1¼" BSP discharge outlet. PUMP Type PTL 30 Vertical, single-stage, submersible, with foot strainer (10x40 mm). Volute casing with 1¼" (male) radial pressure branch. Bearings Common shaft for pump and motor, mounted in ball bearings and grease lubricated for life. Seal Shaft sealing by means of shaft sealing rings and intermediate oil chamber, safe to run dry for short periods. Motor Submersible motor, type of enclosure I P 68, insulation class B, starting via plug or automatic circuit. Completely water tight cable entry. Materials Motor housing in high-grade steel, volute casing, impeller and control head in plastic (GRP), shaft in stainless steel, rubber insulated flexible cable. ALL INVERTS TO BE MADE TO SIDE OF TANK USING TANK CONNECTORS. 1¼" MINIMUM VENT TO AIR REQUIRED. PTL 30 1.70 1.57 1.37 1.15 0.82 0.45 ltr/sec PERFORMANCE PTL 30 Delivery Head/m 1 2 3 4 5 6 The DRAINMINOR comes complete with a one year warranty. In the unlikely event of technical difficulties, please ring: Pump Technology Limited on 01189 821555 IMPORTANT: This unit is not designed to handle sewage. Please enquire about our packaged sewage pumping systems. INSTALLATION DRAINMINOR Installers please note. 1. Remove lid from tank, check pump is correctly positioned and connecting pipework has not been damaged In transit. 2. Check that the pump is correctly positioned in the tank and that the union is tightly connected so that the pump does not move on its mountings impeding the float action. 3. All inverts should be brought into the tank by drilling a hole and using an appropriate tank connector. 4. All inverts should be brought into the tank (using tank connectors) at the highest possible level from the floor - i.e. no lower than 200 mm from base of unit. (with low level float 110 mm) 5. Preferably no connections through the lid as this inhibits easy removal of the lid for cleaning tank. (Note: tank MUST be positioned in such a way that lid can be removed easily to allow access for tank interior and pump cleaning.) 6. Ensure that the inflow of water is not directed onto the float mechanism. 7. A compression fitting can be installed between the non-return valve and the discharge pipework to enable the removal of the DRAINMINOR tank if required. 8. Slow radius bends MUST be used for every change of direction of the 1¼" discharge pipework. 9. If the discharge pipework connects to a soil stack, manhole etc. below the discharge outlet of the tank , an anti-syphon unit MUST be fitted to the highest point of the discharge pipework. MAINTENANCE: The DRAINMINOR should have the lid REGULARLY removed for CLEANING of the Tank and Pump Pump performance is subject to ISO 2548 tolerances. Capacity ± 8% Head ± 6% KW absorbed ± 8%